How do you set up a double bass drum set?

Method 1: Mount two toms on each bass drum using your hardware. Method 2: Mount one tom on each bass drum and mount up to two additional toms on a stand in between the bass drums. Method 3: Mount as many toms as you want on a rack placed in front of the kit. Attach your other desired cymbals to their stands.

Where should I put my double bass pedal?

So, how do you set up a drum set with a double bass pedal? The traditional setup is to attach the primary pedal to the bass drum as you would a single pedal and to place the second, slave pedal just to the right of the hi hat stand’s pedal board.

What does a double bass pedal do?

A double bass drum pedal operates much the same way only with a second footplate controlling a second beater on the same drum. Most commonly this is attached by a shaft to a remote beater mechanism alongside the primary pedal mechanism.

How does a double kick pedal work?

This feat in pedal technology works just like a regular pedal except that a second base plate is attached by a rod to a separate beater mechanism, which operates alongside the primary beater. Like earlier double bass setups, double pedals require both feet to operate.

You might be interested:  Quick Answer: How To Use 2 Single Bass Pedal For Double Bass Pedal?

How do you adjust the angle on a bass drum?

Adjust the angle of the beater by loosening the beater angle cam adjustment square or Allen key bolt (fig 2) then tighten it back up. It’s best to make fine adjustments as too much adjustment either way will prevent the beater from striking the head.

How far should the beater be from the bass drum?

I’d recommend starting by placing your bass drum pedal into position (there’s usually a slot under your bass drum. Then measure a distance of about 3 inch (about 8 cm) or have your beater set at an angle that’s about 45°.

How do you adjust the height of a footboard?

1.2: Footboard Angle To change the footboard height and angle, loosen the adjusting key screw on the top of the Rotor and slide the chain or strap forward or backward to achieve the desired footboard height. Then tighten the adjusting key screw.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *