How do you mix double bass?

Use EQ to give each its own space. Cut the 40-100 range in one track, and cut the 100-200 range in the other track. I typically give the kick the lowest frequencies, and the bass the higher frequencies in this range. But you can try both in each mix, and just choose whatever feels best.

What are the bass frequencies on an EQ?

Summary Table

Frequency Range Frequency Values
Sub- bass 20 to 60 Hz
Bass 60 to 250 Hz
Low midrange 250 to 500 Hz
Midrange 500 Hz to 2 kHz

3

Is Double Bass easy to learn?

The double – bass is not a difficult instrument to start on, although once you get up to Grade 4 or 5 and have to do a lot of “shifting” (i.e. moving your whole left hand up and down the fingerboard to obtain different combinations of notes instead of just your fingers) it’s just as hard as anything else.

How do you EQ string bass?

Increase or decrease the “weight” of the bass by boosting or cutting in the 80 Hz to 100 Hz range. If the bass sounds “boomy,” try cutting a few decibels between 100 Hz and 150 Hz. If the bass tone is lacking “warmth,” boost the EQ between 100 Hz and 300 Hz.

You might be interested:  Question: What Happens When You Double A Bass Line In Ableton?

What does a double bass sound like in words?

Heavy, weighty, dark, weightless, wafting, somber, earthy, resonant, rasping, broad, hollow, dull, mighty, menacing, violent, mellow, sustaining, aspirate.

What size double bass should I get?

The standard size for adults is a ¾ double bass. A large double bass such as a ⅞ or 4/4 is very rare and not commonly used unless the person is very tall, 6.5′ + in height or they have unusually large hands. A general rule for children is to choose a bass one size smaller than usual violin size for age.

Is higher Hz better sound?

This measurement of cycles per second is expressed in Hertz ( Hz ), with a higher Hz representing higher frequency sound. Low-frequency sounds are 500 Hz or lower while high-frequency waves are above 2000 Hz. People with hearing loss usually have trouble hearing sounds in the higher frequency range.

How do you EQ vocals properly?

Best EQ Settings for Vocals

  1. Roll off the low-end starting around 90 Hz.
  2. Reduce the mud around 250 Hz.
  3. Add a high shelf around 9 kHz & a high roll off around 18 kHz.
  4. Add a presence boost around 5 kHz.
  5. Boost the core around 1 kHz to 2 kHz.
  6. Reduce sibilance around 5 kHz to 8 kHz.

What dB should Bass be at?

Typically, without tons of compression the kick and bass and vocals should be hitting very close to 0dbFS. The snare about -3 to -6dbFS. Then mix everything else to match. Then turn down all the tracks down the same amount at the same time until the master channel reads about -3db max.

You might be interested:  Often asked: You Need To Know When You Play Double Bass?

Is violin harder than double bass?

Double bass is harder if you try to put it under your chin. Violin is harder if you try to stand it upright and bow from the side. Played in their normal ways, however, both are equally difficult to master completely. The bass, especially played pizzicato, is easier to play at a level adequate for many kinds of music.

How long does it take to learn the double bass?

If you practice enough I’d say you’d get used to moving around an upright and getting the right feel for it in about 6 weeks or 2 months. But like lowend said, get a teacher, it’ll make the transition much easier.

Should I learn cello or double bass?

Cello is easier to learn, but harder to master. I know that sounds simplistic, but as someone who plays both the cello and the bass I’ve found it to be true. The cello repertoire is far more extensive and demanding than the bass repertoire, and the expectations of cellists are also much higher.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *