Where should I put my double bass pedal?

So, how do you set up a drum set with a double bass pedal? The traditional setup is to attach the primary pedal to the bass drum as you would a single pedal and to place the second, slave pedal just to the right of the hi hat stand’s pedal board.

How can I increase my double kick speed?

Practice Key

  1. Use the heel-toe technique to practice the above exercise with each foot separately.
  2. Play a heel stroke for every written “H” and a toe stroke for every written “T”
  3. Start very slowly and increase your speed only after your control increases.

How do double kick pedals work?

In order to play “doubles” on the pedal, drummers can employ 3 main techniques: slide, swivel, or heel-toe. In the slide technique, the pedal is struck around the middle area with the ball of the foot. As the drum produces a sound, the toe is slid up the pedal.

How far should the beater be from the bass drum?

I’d recommend starting by placing your bass drum pedal into position (there’s usually a slot under your bass drum. Then measure a distance of about 3 inch (about 8 cm) or have your beater set at an angle that’s about 45°.

How do you adjust the angle on a bass drum?

Adjust the angle of the beater by loosening the beater angle cam adjustment square or Allen key bolt (fig 2) then tighten it back up. It’s best to make fine adjustments as too much adjustment either way will prevent the beater from striking the head.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *