Where should a double kick pedal go?
So, how do you set up a drum set with a double bass pedal? The traditional setup is to attach the primary pedal to the bass drum as you would a single pedal and to place the second, slave pedal just to the right of the hi hat stand’s pedal board.
What does a double bass pedal do?
A double bass drum pedal operates much the same way only with a second footplate controlling a second beater on the same drum. Most commonly this is attached by a shaft to a remote beater mechanism alongside the primary pedal mechanism.
How do you adjust the angle on a bass drum?
Adjust the angle of the beater by loosening the beater angle cam adjustment square or Allen key bolt (fig 2) then tighten it back up. It’s best to make fine adjustments as too much adjustment either way will prevent the beater from striking the head.
How do you adjust a DW 3000 double bass pedal?
To increase or decrease the spring tension, loosen the round knurled nut at the base of the spring assembly and pull down on the spring to release the locking hex nut. Tighten or loosen the lock nut to create the desired tension, then release the hex nut and retighten the knurled nut to lock in the adjustment.
What should I look for in a bass drum pedal?
4 things to look out for when choosing a bass drum pedal
- Pedal Drive.
- Playing Feel.
- Ease of Maintenance.
How far should the beater be from the bass drum?
I’d recommend starting by placing your bass drum pedal into position (there’s usually a slot under your bass drum. Then measure a distance of about 3 inch (about 8 cm) or have your beater set at an angle that’s about 45°.