How do you set up a double kick drum?

Tips For Setting Up Your Double Bass Drum Pedal

  1. 1 – Master Pedal Attachment: Attach the master pedal to the bass drum in the usual way.
  2. 2 – Test and Adjust the Master Pedal:
  3. 3 – Hi Hat/Snare Setup:
  4. 4 – Place You Slave Pedal.
  5. 5 – Connect the Slave and Master Pedals.
  6. 6 – Test and Adjust the Slave Pedal.

How do you set up a double bass drum set?

Method 1: Mount two toms on each bass drum using your hardware. Method 2: Mount one tom on each bass drum and mount up to two additional toms on a stand in between the bass drums. Method 3: Mount as many toms as you want on a rack placed in front of the kit. Attach your other desired cymbals to their stands.

Should I get a double bass drum pedal?

Double pedal technique requires a big investment of time to master, If you are a session musician you will possibly use it, but If its not something you require for the music you play then the time could be better used perfecting the style of drumming you like and use. If its something you want to get into then do it.

You might be interested:  Quick Answer: How To Change A Single Bass Drum Mount To A Double?

Should I get a double bass pedal?

Double Pedal is rarely a necessity unless you’re playing the extreme forms of metal. Still, if you ever hear tasteful use of double bass playing it can make you want to get one.

How far should the beater be from the bass drum?

I’d recommend starting by placing your bass drum pedal into position (there’s usually a slot under your bass drum. Then measure a distance of about 3 inch (about 8 cm) or have your beater set at an angle that’s about 45°.

Where should the beater hit the bass drum?

As a general rule the beater should strike the bass drum slightly higher than center. About an inch above works for most folks. If the beater hits directly on center the head tends to bounce more and it flams against the head easier if it is buried into the head.

How does a double kick pedal work?

This feat in pedal technology works just like a regular pedal except that a second base plate is attached by a rod to a separate beater mechanism, which operates alongside the primary beater. Like earlier double bass setups, double pedals require both feet to operate.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *